Vidikron SERIES 1080p, Руководство пользователя

Страница: 77 / 88

Vidikron Vision 70 Series Owner’s Operating Manual 65
PRE
L
IMINAR
Y
6.1
RS-232 Connection and
Port Configuration To interface the Vision 70 with a home theater automation/control system or a PC running
terminal emulation software:
1. Connect it to your control system or PC as shown in Figure 3-12.
2. Start a terminal session on your PC using a terminal-emulation program, such as
HyperTerminal.
3. Configure the RS-232 controller or PC serial port as follows: no parity, 8 data bits, 1 stop
bit and no flow control. Set the baud rate to match that of the projector (115200, 3 8 400
or 9600).
4. Press
<Enter>.
You should see a command prompt (>) in the terminal window.
5. Type a command from among those listed in Table 6-1 and press
<Enter>.
For
example, to change the aspect ratio to Letterbox, type
x063x <Enter>
.
6.2
Serial Command Syntax Serial commands to the Vision 70 take the following form:
• Commands are in ASCII format.
• Commands are not case-sensitive;
X001X
and
x001x
are equivalent.
• A carriage return MUST follow each command.
6
Serial Communications
The Vision 70 will not accept serial commands for 20 seconds after it is
turned on or off.
Table 6-1. Serial Commands
Code Function
x001x Power On
x002x Power Off
x003x Menu
x004x Enter
x005x Exit
x006x Up (arrow key)
x007x Down (arrow key)
x00 8 x Left (arrow key)
x009x Right (arrow key)
x011x Show active source and aspect ratio information
x021x Keypad 1
x022x Keypad 2
Note