Operation
46
Vidikron Vision Model 10/Model 12 Owner’s Operating Manual
PRE
L
IMINAR
Y
ISF Setting
Use the ISF Setting menu to perform advanced picture quality adjustments.
This menu
should be used by ISF-certified technicians only.
Several controls in this menu are identical to those in the Picture Adjust menu, but are
accessible only by entering the ISF Calibration menu passcode. This makes it possible to
restore the picture quality settings to what they were when the projector was installed,
simply by recalling the “ISF Night” or “ISF Day” preset.
Brightness:
Refer to
Brightness
on page 37.
Contrast:
Refer to
Contrast
on page 38.
Color:
Refer to
Color Saturation
on page 38.
Tint:
Refer to
Tint
on page 39.
Sharpness:
Refer to
Sharpness
on page 40.
Gamma:
Refer to
Gamma
on page 40.
Color Temp:
Refer to
Color Temperature
on page 41.
Picture Setting:
To recall the Custom1, ISF Night or ISF Day settings, choose Picture Setting
from the ISF Calibration menu. Then, select “Custom1,” “ISF Night” or “ISF Day” and press
ENTER
, or use the corresponding buttons on the remote control.
White Balance:
Refer to
White Balance
on page 42.
Save Settings:
For each input and supported resolution, the Vision 10/12 lets you save
image quality settings as presets that you can recall at a later time. You can create up to three
presets -- designated “Custom1,” “ISF Day” and “ISF Night” -- per input and resolution.
You should save changes to any of the following settings to a preset; otherwise they will be
lost when a new input source or resolution is selected:
• Aspect ratio
• Picture adjustments (brightness, contrast, color saturation, tint, sharpness, gamma, color
temperature, ICC selection and white balance settings)
• Image options (SDTV adjust settings, brightness enhance, lamp power)
To save image settings in the “ISF Day” or “ISF Night” preset, select Save Settings from the ISF
Calibration menu and select “ISF Day” or “ISF Night.” (To save settings to the “Custom1”
memory preset, refer to
Save Settings
on page 42.)
Lamp Timer Reset:
When you replace the projector lamp, you should also reset the lamp
hour counter. To do this, select Lamp Timer Reset from the ISF Calibration menu and press
ENTER
. The Vision 10/12 shows the number of hours the projector lamp has been in service
and asks you to confirm or cancel the reset. Press
ENTER
to confirm or
EXIT
to cancel.
For detailed lamp replacement instructions, refer to
Lamp Replacement
on page 52.
ISF Calibration
Brightness
0
Contrast
0
Color
0
Tint
0
Sharpness
3
Gamma
2.2
Color Temp
6500K
Picture Setting
White Balance
Save Settings
Lamp Timer Reset
ICC Adjust
Standard
ISF Enable
OFF
Blue Enable
OFF
Splash Screen Timer
60 secs
Noise Reduction
4
➤
You must enter a passcode to access the ISF Setting menu.
Note
Содержание DLP 40828
