Vidicode 1370 LS120, Руководство пользователя

Страница: 88 / 102

Call Recorder Manual ©-2001 Vidicode Datacommunicatie BV
88
seconds by default. If you regularly make several phone calls close together
press the “telephone” key in between calls to speed up this process. The
current recording will be stopped, after which a new recording can be started.
(see the problem below)
The Call Recorder “just” starts to record while nobody is calling
This can only happen when the recorder has been set to “line” or “handset”,
and is caused by the handset picking up sound even when not being used.
Some digital or semi-digital phones tend to do this. There are two solutions to
this problem:
•
First try using the other channel to start recording on as explained
under ‘setting the start signal’ in section 3.1.2
• Alternatively try increasing the “switching-on” signal level slightly
When I listen to a recorded conversation, I can hear the one party very
clearly, but the other party sounds very weak or far too loud.
This problem almost exclusively occurs when the source of the signal is a
handset, because when recording from a handset two separate channels
(microphone, and loudspeaker of the handset) are mixed. The difference in
level between these two channels can be adjusted with the signal settings.
Experiment a little bit, to find out which settings give the best result, as each
telephone handset has its own characteristics.
I can phone with the Call Recorder, but do not seem to be able to
transfer a call.
There are two possible causes of problems with transferring calls:
1. The Call Recorder has been incorrectly programmed. In the “Telephone
settings” menu you find “Put on hold”, which can be set to “Hook-Flash”
or “Earth Flash”. The next value that can be changed is the time of the
flash. The supplier of your telephone exchange will be able to tell you
which values are applicable to your telephone.
2. The cables between the Call Recorder and the wall connection have
been incorrectly connected, thus preventing the transfer key in