Videx ESVK Series, Руководство по установке

Страница: 14 / 40

66550029-EN - V4.0 - 15/02/19
- 14 -
ESVK/6788 Series “2 wire Bus” videokit
ESVK/6788 Series - Installation handbook
ADHESIVE GASKET PLACEMENT
Apply the
Y
seal as shown in
Fig. 5
.
ANTI-TAMPERING LOCKS FIXING
Fit the anti-tampering locks
W
as shown in Fig. 6 .
Y
G
Fig. 5
W
Fig. 6
HOW TO REMOVE/INSERT THE CARD NAME HOLDER
• To avoid damage to the module front plate, mask the side that
will be in contact with the screwdriver blade;
• Insert the screwdriver (flat side) into the card-holder hole as
shown in
Fig. 7
;
• Move the screwdriver to the left as shown in
Fig. 8
to extract
the card name holder;
• Edit the card name then replace it inside the holder and refit:
insert the holder inside its housing from the left or right side
then push the other side until it clips into place.
Fig. 7 Fig. 8
SIGNALS ON SYSTEM CONNECTION TERMINALS
VID2
Video signal input (coax centre core)
GNDV Video signal ground (coax screen and 0V to camera)
+V2
Output to supply the external camera
if necessary
Max 12Vdc
150mA
EB2
Expansion button input 2
EB1
Expansion button input 1
GND Ground
BUS
BUS Connection terminals
BUS
PTE
“Push to exit” active low input
GND
Ground
GND
NO
Door open relay normally open contact Max 12-24
Vac/dc 2A
C
Door open relay common contact
+C Electric lock capacitor discharge output
VAUX
35Vdc power supply input (if used, the module is
powered locally and not from the BUS)
NC
Door open relay normally closed
contact
Max 12-24
Vac/dc 2A
CLEANING OF THE PLATE
Use a clean and soft cloth. Use moderate warm water or non-ag-
gressive cleansers.
Do not use:
• abrasive liquids;
• chlorine-based liquids;
• metal cleaning products.
UNIT SPECIFICATION
Housing/Mounting:
One 4000 Series Module / 4000 Series
Modular System
Push Buttons:
Yes, from 0 to 2 call buttons depend-
ing on the model
Programming:
Yes, carried out by the 8 way dip-switch
located on the rear of the module
Controls:
Microphone and Loudspeaker volume
trimmers plus balance trimmer
Power Supply:
Supplied by the BUS line
Power consumption:
Stand-by: 50 mA
Operating: 165 mA
Working Temperature:
-10 +50 °C
Art. 4333/4333X
Speaker unit module with built-in functional to digital interface