EN - English - I
nstruc
tion manual
12
MNVCNXM36_2051_EN
6.3.3.2 Operating status
The LEDs shown in the figure allow to check the
product's operating status.
LD3
LD1
LD2
Fig.
9
Refer to the table to identify the operating status.
OPERATING STATUS
LED
LED Status
Apparatus Status
LD1 (Ca-
mera)
Off
The camera is not connected
On
The camera is correctly powered
1 flashing
The camera has a low identification
resistance
2 flashings
The camera has a high identifica-
tion resistance
5 flashings
The camera has an excessive ener-
gy consumption
9 flashings
The camera requires more energy
than the available
LD2 (Power
supply)
Off
The device is not powered
On
The device is correctly powered
LD3 (Heater) Off
Heating is inactive
On
Heating is active
Tab.
4
6.4 Housing closure
Before closing the housing reinsert the bottom
orientating the slide according to the installation
required, for the right camera fitting (6.1 Installation
mode, page 9).
Pay attention not to damage the gasket.
Make sure that the sealing ring is correctly fitted in
its position.
Pay attention to the fixing. Tightening
torque: 2.1Nm.
6.5 Sunshield mounting
(according to model)
Between the sunshield and the flanges of the
housing, position the spacers supplied. Fasten
the sunshield to the housing with the screws and
washers supplied, corresponding to the spacers.
Fig.
10
