Videotec HEG, Инструкция по эксплуатации

Страница: 9 / 54

Instruc
tions manual - English - EN
7 MNVCHEG_1511_EN
6.1.5 Installation of the version with
double filter for air renewal
During installation pay attention to the
orientation of the air inlet filter fins.
OUT
Fig. 4
To guarantee the weatherproof, install the housing
on the support following the inclination limits as
shown in the picture.
Depending on the angle of inclination of the housing,
the orientation of the filter fins must prevent water
penetrating in case of rain:
0˚
45°
45°
Fig. 5 Maximum tilt of the transversal axis: 0°.
Maximum tilt of the longitudinal axis: ±45°.
6.1.6 Desiccant bag
Take the dessicant salt bag out of its pack and insert it
into the product.
7 Accessories
For further details on configuration and use,
refer to the relative manual.
7.1 Heater
7.1.1 Heater installation
At the end of istallation, connect the wiring to
the terminal (heater power supply, 6.1.3 Board
description, page 6).
7.2 Camera power supply
7.2.1 Camera power supply installation
Not usable in housings with wiper device
installed.
Pay attention to the voltage value used
when the circuit is powered. Depending on
requirements use the correct power supply
kit.
There are 2 types of camera power supply depending
on requirements.
Fig. 6
V
IN
from 100Vac a 240Vac, V
OUT
12Vdc.
Fig. 7 V
IN
230Vac, V
OUT
24Vac.
At the end of istallation, connect the wiring to the
terminal (power supply connector, 6.1.3 Board
description, page 6).