videogeniX uSwitch, Инструкция по установке и эксплуатации

Страница: 38 / 43

uSwitch and uSwitchPro Installation and Operating Manual Page 38
Appendix A: Factory Default Settings
In the event that the IP address or passwords are forgotten and you cannot log in to uSwitch, you can reset uSwitch to its
factory default settings. With power press the reset button for about five (5) seconds (you should feel or hear the reset pin
click). After approximately five (5) seconds, release the reset button. Wait thirty (30) seconds then cycle power on
uSwitch. At this point all settings should be restored to factory default settings (shown below)
Network Configuration:
Host Name: U-SWITCH
Enable DHCP: unchecked
IP Address: 192.168.1.199
Gateway: 192.168.1.1
Subnet Mask 255.255.255.0
HTTP Port: 80
Primary DNS 8.8.4.4
Secondary DNS 8.8.8.8
Auto Discovery: checked
MAC Address: Predefined at Factory (non-configurable)
Relay Configuration:
User Assigned Name Relay1/Relay2
User Assigned Text On (Off)
User Assigned Colors Red/Green
Power Up State: Last (sets relay to return to previous state after each uSwitch power cycle)
Momentary(sec): 0 (non-momentary)
Ping Auto Reboot: unchecked
Allows Master Control: unchecked
Sync to Local GPIO unchecked
Sync Inverts GPIO unchecked
Timed Reboot (hours) Off
Link Buttons Together: unchecked
GPIO Configuration:
User Assigned Name GPIO1/GPIO/2
User Assigned Text On (Off)
User Assigned Colors: Red/Green
Enable Counting
unchecked
Watchdog Configuration:
URLs to Ping
External Heartbeat: unchecked
URL Primary: 8.8.8.8
URL Secondary: 4.2.2.2
URL Tertiary 192.168.0.1
Verify All URLs: unchecked
Auto Reboot Counters
Max Ping Failures: 3
Max Reboot Attempts 3
Auto Reboot Timers
Mode Start Delay: 5 min, 0 seconds
Time Between Pings: 1 min, 30 seconds
Relay Cycle Time: 5 Seconds
Fault Mode Timer
Period Before Retry on Fault: 4 hours, 0 minutes, 0 seconds
Authorization Configuration
Username: “admin”
User Password: “admin”
Admin Password: “admin”