Programming/RF Testing/Mounting
The following provides summarized steps for device
programming, testing, and mounting. For complete details,
refer to the control panel installation manual.
1
Separate the base from the box
2
Install 4 3.6V LS14500 SAFT
batteries observing correct polarity.
3
Put control panel into
Programming/Configuration mode.
4
Using a programmed
alphanumeric keypad, proceed
through menus until the display
shows ADD A NEW DEVICE.
5
Press OK/YES. the display shows PRESS PROGRAM
BUTTON OF DEVICE.
6
Press and release program button
on the OMV MotionViewer.
The OMV PIR flashes.
7
Wait for keypad display to show
CAMERA(1 - 25) PROGRAMMED. Press
OK/YES, the display shows RADIO
RANGE TEST? Press OK/YES again. The
camera LED starts flashing and keypad
display shows RF TEST.
8
Take the OSMVC camera to its intended mounting location
and make sure LED flashes continuously or you receive a 9/9
indicating good communication with the control panel.
9
Press OK/YES to end radio range test then press ESC/NO.
10
The keypad displays :
AREA ALLOCATION :
AREA : 1
Press either arrow button repeatedly until desired area number
appear then press OK/YES. By default all devices in Area 1 are
automatically delayed.
11
The display shows NAME + LOCATION:
Enter appropriate device name/location (up to 16 characters),
then press OK/YES. The display shows the device number and
name for your verification.
12
Mount the OSMVC on the MB 110 or the MBW110 Mounting
kit. Follow the installation guidelines shown in this document.
13
Press OK/YES. The display shows FUNCTIONAL DEVICE
TEST? Press OK/YES and verify camera operation. The
activation of the LED will determine the detection field.
14
Press OK/YES to end detection verification.
15
The display shows OPERATION COMPLETED or ADD A
NEW DEVICE? Press YES/OK. Repeat steps 1 – 14 for remaining
cameras.
16
When finished, exit from configuration mode.
Screw
Program button
2
INSTALL SHEET
OSMVC
OUTDOOR STREAMING MOTION VIEWER
