Programming/RF Testing/Mounting
The following provides summarized steps for device programming,
testing, and mounting. For complete details, refer to the control panel
installation manual.
1
Loosen bottom screw. 1
Separate base from IMD. 2
2
Install 1 SAFT LS14500 3.6v batteries, observing correct
polarity.
3
Put control panel into programming/configuration mode.
4
Using a programmed alphanumeric keypad, proceed through
menus until the display shows ADD A NEW DEVICE.
5
Press Yes. The display shows PRESS PROGRAM BUTTON OF
DEVICE.
6
Press and release program button on the IMD using your finger
or a screw driver 1 . The programming button is located inside the
product on the top of the main PCB.
The IMD LED flashes red 2
.
7
Press Yes. The display shows RADIO RANGE TEST? Press Yes
again. The IMD LED starts flashing and keypad display shows TEST IN
PROGRESS.
8
Move the IMD to the intended mounting location and make sure
you receive a 9/9 indicating good communication with the control
panel.
9
Press YES to end the Radio Range Test, then press ESC/NO.
10
The display shows AREA ALLOCATION; AREA: 1. Press either
arrow button on the keypad until the desired AREA number appears,
then press YES. By default all devices in area 1 will be subject to the
entry and exit delays.
11
The display shows NAME + LOCATION:
Enter an appropriate device name (up to 16 characters). The name of
the device should describe its intended mounting location or zone.
Press YES. The display will show the device number and name for your
verification.
12
Mount the IMD on the wall:
>
Follow the mounting rules on page 1
>
Drill desired mounting holes in the IMD base and mark the
appropriate mounting holes on the wall.
>
Drill pilot holes and install anchors where needed.
>
Place base on mounting surface so that the pilot holes line up and
secure base with appropriate screws.
>
Attach detector to base and secure with screw if required.
13
Press YES. The display shows FUNCTIONAL DEVICE TEST?
Press YES again and verify IMD operation. For example,
wave your hand in front of the sensor to activate the LED
which indicates detection.
14
Press YES to end the detection verification
15
The display shows ADD A NEW DEVICE? Repeat steps 1-14 for
remaining Devices.
16
When finished, exit from configuration mode by pressing and
holding the ESC/NO for 5 seconds.
①
②
②
Wait for keypad display to show DETECTOR (1 - 24) PROGRAMMED.
①
②
*Check that the LED flashes before staying RED
①
1
1
2
2
I N S T A L L A T I O N S H E E T
Indoor MotionViewer
IMD
200/601/701
www.videofied.com
