28
4Ch Real time/Triplex/Mux
- Stand Alone DVR
2) PAN/TILT SETUP
COMMAND SETUP
SPEED SETUP
ESC
PAN/TILT SETUP
01
PELCO-D
000
2400 BPS
1 MSEC
PAN/TILT STOP
16
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
ALL-DEFAULT ESC
CHANNEL
MODEL
PTZ ID
BAUDRATE
CMD DELAY
COMMAND
LENGTH
CODE
DEFAULT
COMMAND SETUP
1) CHANNEL : Select channel
2) MODEL : Select camera model (protocol type) per each channel
3) PTZ ID : Select PTZ ID (per each channel)
4) BAUDRATE : Select data transmission speed
5) CMD DELAY : Select command delay time
PAN SPEED 7
TILT SPEED 7
ZOOM SPEED 7
FOCUS SPEED 7
DEFAULT ESC
PAN/TILT SETUP
CHAP. 5 Set up
Å
PTZ Camera setup
Å
PTZ Speed setup
3) SPOT SETUP
SWITCH INTERVAL 03 SEC
ALARM POP UP ON
MOTION POP UP ON
EVENT POP UP DURATION 05 SEC
DEFAULT ESC
SPOT SETUP
(1) SWITCHING INTERVAL
Channel switching time (01 sec. ~ 99 sec.)
(2) ALARM POP-UP
When ALARM is detected, the image of channel
connected with Alarm sensor pops up.
Set ALARM detection pop-up (ON/OFF)
(3) MOTION POP-UP
Set MOTION detection pop-up (ON/OFF)
If events (MOTION or ALARM) happen on several channel at the same time, channel No. 1
has the first priority to pop up. For example, if events happen on channel No. 1, channel
No. 2, and channel No. 4 at the same time, channel No. 1 pops up. If the motion
disappears on channel No. 1, then channel No. 2 pops up for the duration that you set.
However, even though motion happens on channel No. 1 again within the duration,
channel No. 2 still displays. If motion on channel No.1 keeps on going even after the
duration, channel No. 1 pops up again.
※
EVENT POP-UP DURATION
Set EVENT POP-UP DURATION