vidaXL 60798, Руководство по эксплуатации и технике безопасности

Страница: 57 / 164

57 EN___User manual |
D Feminine shower button
E Shower Strength / Wind Temp. Adjustment Button
F Drying pad
G Shower Temp. select button
H Water Temp. Indicator
I Power Saving Button
J
Power Saving Indicator
K Purifying Indicator
L Lighting Button
M Power button
N Seat temp. Select indicator
O Shower Force / Wind Temp.Indicator
P Forced Shower Button
5 Installation instructions
5.1 Installation of the main unit
See image 4
5
Note: Water pressure regulator must be installed on the
inlet pipe, otherwise it may cause damage to the water tank!
The installation bolt of the unit’s fixed plate is adjustable in the
node distance range of 140-200 mm.
1. Remove the existing toilet and seat cover. Release the bolts
to remove the old seat.
2. Take off the fixed plate of unit. Unpack the fixed plate from
the bottom.
3. Installation of the fixed plate: Set the position and then
fasten the fixed plate onto the toilet. Push down the
unpacking button and lift the fixed plate upward at the
same time.
4. Installation of the main unit
See image 5
To fit the pallet into the unit fixing socket, place the seat at
indication A as shown in the image . Lift the holding parts of the
unit upward and insert it with a clamp.
5
Note
• Take care do not to place the lead between the unit and the
toilet bowl.
• After installation, lift the unit gently upward to check if it is
fixed.
5.2 Installation of the branch junction valve
1. Close the water supply valve and disassemble the feed
water pipe.
2. Connect the branch junction valve to the water supply
valve.
3. Installation of the feed water pipe.
5
Note
While tightening the nuts, make sure the floater in the water
reservoir works well.
5.3 Connecting of the feed water pipe
1. Connecting it to the branch junction valve.
• Make the screw thread junction of the branch junction
valve face toward a point of the pipe that is easy to install.
• Tighten the metal nut with a monkey wrench.
2. Connect it to the main unit.
• Insert the feed water pipe straight into the body joint.
• Tighten the pipe joint with a monkey wrench.
5.4 Adjustment of the water supply valves
• Open the water supply valves of the feed water pipe and
the branch junction valve. Closed valves can obstruct the
water flow.
5.5 Trial operation
Before trial operation, to do the following:
• Check if the valves are open.
• Check if the water leaks at the joints.
5
When showering is stopped, there will be drops of water
near the nozzle for 3 mins, it is not a defect.
5.6 Tips after installation
1. Follow the maintenance instructions in the user manual.
2. If it is not used for a long period, please drain off the water.
How to drain off the water:
1. Unplug the power plug.
2. Close the water supply valve.
3. Lift up the toilet.
4. Take out the drain hole cap.
5. Drain the water then put the cap back.
6 Operation Guide
5
Please make sure the power plug is plugged into the outlet
before you open the water valve.
6.1 Water supply
• During first usage, touch “Sensor location” on the seat ring,
water will go into the water reservoir and the lights will
flash automatically.
• Once the water level has reached the limit, the lights will go
off.
6.2 Water temp heated
• When water temperature is high, the water temp indicator
will start flashing. When the water temperature is
controlled, the temperature will be displayed.
• Press the “Water Temp” button repeatedly to adjust the