Vidalux Hydro Plus Series, Инструкция по установке и эксплуатации

Страница: 10 / 35

8
LEVELING AND FITTING THE TRAY
Remove the protective fi lm covering the base.
Connect the soil pipe, trap and any couplings to the fl exible waste under the tub. You may choose to
fi t either a HEPV0 trap with the appropriate couplings or choose to fi t a McAlpine ST28M coupling to a
McAlpine 28-NRV trap.
Position the tub base in what will be its fi nal location and adjust the feet until the base is level. You can
raise/lower the feet under the tub and with a spirit level laid across the tub, ensure the tub is level.
No w fi ll the base with some water and check that the water fl ows adequately to the plug and exits
satisfactorily. If the water does not fl ow to the plug fully, then you will need to increase the fall on the
tray by adjusting the legs. If the water does not exit the waste section fast enough, then ensure there is
suitable fall in the waste pipe and/or no blockage or kinks in the pipe work.
Check and attend to any leaks.
Now slide the tub away from the wall to allow access all around the shower as you assemble.
This product is freestanding so you do not need t o fi x the feet t o the fl oor.
FITTING THE CONTROL PANEL
Simply remove the paper backing to the waterproof sponge to reveal
the sticky backing. From the front of the shower offer the control panel
into the void on the center control tower and press lightly into place.
Once in place, from the back of the tower use the 4 screws and washers
to firmly secure the control panel.
Again coming to the front of the shower, now press hard and firmly on
all edges of the control panel to further seal and then tighten screws
once more