I N S T A L L A T I O N
15
Connect the Wireless Keyboard
After installing the video and audio outputs, it is time to connect and synchronize the
wireless keyboard to its receiver. Make sure that the wireless keyboard receiver is
connected to the VidaBox™, and start the SLIM™ by pressing the
D
Power Button.
1.
Place the 3 included ‘AA’
batteries into the keyboard.
Be careful to observe polarity
– improper battery installation
may damage the keyboard.
2.
Connect the USB receiver to
the USB extension cable, and
place the USB receiver in a
location where it will have
full line-of-sight with your
keyboard at all times
.
3.
Bring the wireless keyboard
within 3 feet to the USB
receiver with clear line-of-sight
(i.e. no obstructions).
4.
Look for a small “sync” button on the USB receiver, as shown on the right. Be
sure it is connected to the VidaBox™ and the VidaBox™ is turned
on
.
5.
Using a paper clip or other small object, press and hold this button down for at
least 3 seconds.
6.
On the wireless keyboard, hit the synchronization button, as shown on the left.
7.
Give the keyboard a few moments, and it should connect to the USB receiver.
8.
If this does not work, try replacing the batteries with a fresh set and try again from
step 2.
Note: For battery replacement, note that less expensive, non-brand name “value”
batteries are not recommended for use with our equipment, as they may not supply
enough energy for performance. If the problem persists, please contact us.
Keyboard
Synchronization
Button
Press this button to
synchronize the wireless
keyboard with its
receiver.
Receiver
Synchronization
Button
