Victron energy Skylla-IP65, Руководство пользователя

Страница: 19 / 20

9. Error indication
Error nr Description Possible cause Solution
1 battery temperature
too high Overcharging or fast charging Check air flow near the battery Improve
cooling of environment. The charger
stops automatically and will resume once
the battery has cooled down
2 battery voltage too
high Wiring mistake, or another charger
is over charging Check all charging equipment.
Check cables and connections
3, 4, 5 temp. sense error Wiring mistake or temperature
sensor broken Check the temperature sensor wiring and
if that doesn’t help replace the
temperature sensor
6, 7, 8, 9 voltage sense error Wiring mistake Check the voltage sensor wiring.
17 charger temperature
too high The heat generated by the charger
cannot be removed Check air flow of the cabinet.
Improve cooling of environment.
The charger stops automatically and will
resume once the charger has cooled
down.
18 Internal error Contact your dealer
20 charger bulk time
expired After 10 hours of bulk charging, the
battery voltage has still not reached
the absorption voltage. Possible cell failure or higher charge
current needed.
24 Fan failure This error indicates that the fan is
powered on but the circuit does not
measure any current draw by the
fan. Most likely the fan is either
broken or obstructed. Contact your dealer
34 Internal error Contact your dealer
37 No input voltage
(only for the three
output version) Mains removed or ac-input fuse
blown Check mains availability and fuse.
65 charger disappeared
during operation One of the other chargers with which
this charger was synchronizing has
disappeared during operation To clear the error, switch the charger off
and back on.
66 Incompatible device The charger is being paralleled to
another charger that has different
settings and/or a different charge
algorithm Make sure all settings are the same and
update firmware on all chargers to the
latest version.
67 BMS connection lost Connection to the BMS lost Check the VE.Can bus cabling. When the
charger needs to operate in standalone
mode again, go to the setup menu #31
(BMS Present) and set to N.
113, 114 Internal error Contact your dealer
115 Communication error Check wiring and terminators
116, 117,
118 Internal error Contact your dealer
119 Settings invalid Restore defaults in the setup menu #62.
Skylla-IP65
Page 17 Error indication