I
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/fV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator &
your body.
I
7
EARPHONE OPERATION
Plug the earphone jack into the earphone port on the function panel to listen to the
record. The built-in speaker will stop playing once the earphones are plugged in.
NOTE: For best performance and product maintenance, unplug the turntable when
not in use.
FCC STATEMENT
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class
B di�ital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including interference that may cause
undesired
operation of the device.
The term “IC: “ before the certification/registration number only signifies that the
Industry
Canada technical specifications were met. This product meets the applicable
Industry Canada
technical specifications.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS
(RSS)
d'Innovation, Sciences et Développement économique Canada. L'exploitation est
autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible
d'en compromettre le fonctionnement.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna transmitter. End-user must be provided with transmitter operating conditions for
satisfying RF exposure compliance.
L'antenne ou les antennes utilisées pour cet émetteur doivent être installées de manière à assurer
une distance de séparation d'au moins 20 cm vis-à-vis de toutes les personnes et ne doivent pas
être co-localisées ni utilisées conjointement avec un autre émetteur d'antenne. Conditions de
fonctionnement pour satisfaire à la conformité d'exposition RF.
