8
Setup / Basic Operation
Setup
1. Remove white protective needle cover by gently pulling towards front of unit.
2. Remove any packaging materials from the unit.
3. Connect the AC power cord to a wall outlet.
Note:
-It is strongly recommended that this product should be operated only from the type of power
source indicated on the marking label.
-To prevent interference, avoid bundling audio signal cables together with the AC power cord.
Basic Operation
1. Move the POWER toggle to the ON position. The LED light around the radio dial will light up.
2. Select a play mode by rotating the function knob (FM/CD/USB/BT/AUX/PHONO/TAPE).
3. Rotate the VOLUME knob to adjust the desired level of sound.
Listening through RCA LINE OUT
For amplifier device listening, first reduce the volume level to minimum. Insert the white and red
plugs on the RCA cable into the back of the unit, then insert the opposite end into your amplifier
device. Be sure to connect the white plug into the white jack and the red plug into the red jack.
Listening through Earphones/Headphones (
not included)
For private listening, first reduce the volume level to minimum.
Insert your headphones’ plug into the 3.5mm jack, then
adjust the volume up by turning the VOLUME knob.
Note:
The speakers will automatically be deactivated while
headphones are plugged in.
CONDENSATION WARNING:
When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the
danger that water vapor in the air may condense on the unit, preventing proper operation. In such cases, leave the
unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.
Listening to the FM Radio
1. Rotate the Function Knob to select “FM”. The LED Display will display “rAd”.
2. Tune to the desired station using the Radio Tuner Knob.
Listening to a CD/CD-MP3/WMA
1. Rotate the Function Knob to select CD. The LED Display will display “Cd--”.
(Note:
When no disc is set, “disc” will appear on the display.)
2. Press the OPEN/CLOSE button to open the tray.
Note:
- This button only works in CD mode.
- CD door takes four (4) seconds to open when
OPEN/CLOSE is pressed in CD mode.
3. Place a disc on the tray with the printed label face up.
4. Press the OPEN/CLOSE button
to close the tray.
5. Then it will begin to play back from the first track automatically.