8
REMOTE CONTROL BATTERY INSTALLATION
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment, a reserved battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from possible leakage.
5. Do not try to recharge the battery as it is not intended to be recharged; it can overheat and rupture.
(Follow the battery manufacturer’s instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine or fire.
7. Clean the battery contacts and also those of the device prior to battery installation.
8. The remote control is supplied with a coin/button
cell battery. If the coin button cell battery is
swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new
and used batteries away from children. If the
Battery compartment does not close securely,
stop using the product and keep it away from
children. If you think batteries might have been
swallowed or placed any part of the body, seek
immediate medical attention.
CR2025
CAUTION
●Danger of explosion if the battery is incorrectly replaced.
●Replace only with the same or equivalent type.
Fig.2
Fig.3
Fig.4
Remote Control Operation Range
●
● When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light
shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.
When there is an obstacle between the transmitter and the unit, the unit may not operate.
Remove and discard the insulation film as shown on Fig. 1.
RELEASE
PUSH
OPEN
R2025
C
+
SN
Fig.1
1. Push and slide out the battery holder as shown on Fig.2.
2. Replace the battery with a new CR2025 button cell as the polarity
marking facing upward as shown on Fig.3.
3. Close the battery door as shown on Fig.4.
FIRST TIME USE
BUTTON CELL REPLACEMENT
BATTERY PRECAUTIONS
