Victory FS-1D-S7, Инструкции по установке, эксплуатации и устранению неисправностей

Страница: 6 / 19

iv
equipment such as ovens, ranges, heaters, fryers, steam kettles, etc., and out of direct sunlight.
Avoid locating the self-contained refrigerator or freezer in an unheated room, or where the room
temperature may be below 55°F.
Installing Casters or Legs
Refrigerators and freezers are shipped with 1/2” single stud mounted legs or casters.
1. Casters / legs must be screwed by hand into the threaded holes located on the case
bottom
(*Note: Once the caster cannot be turned, using a 3/4” box wrench, tighten the
nut in between the mounting plate and wheel of the caster until it is snug).
2. Tilt the cabinet in one direction approximately eight inches and block it securely with
several pieces of 2 x 4 lumber or other suitable material.
3. Screw in the two left or right casters/legs.
4. Repeat this procedure to install the other casters/legs.
Leveling
Cabinets must be leveled when installed. Failure to level your cabinet may result in doors not
sealing, closing properly or condensate water not draining properly.
Casters - Cabinets with casters can be leveled by placing large flat washers in
between 1/2” stud and holes located on the case bottom.
Legs - Rotate the foot of the leg with an adjustable wrench to achieve desired height
for leveling.
Cabinet Cleaning
Prior to placing your new refrigerator/freezer and all shelves, pans and slides into operation, it is
advisable that the interior be washed thoroughly with a mild detergent and water solution. Rinse
with clear water and a sanitizing solution. Allow cabinet to air dry.
Installing Shelves
All cabinets with shelves are supplied with pilasters and shelf clip supports. Shelves are easily
installed by inserting the shelf support clips into the pilasters so they fit tightly. Align the shelf so
the smaller fill wires run from front to rear and rest the shelf on the clips.