4
To obtain the best performance, the following procedure is suggested:
(a)
Switch on the refrigeration system via the switch located on the control panel.
(b)
Depending on the ambient temperature, allow the display approximately 30
minutes to reach the required temperature.
(c)
Load the display as required, be careful not to over pack the display and restrict
airflows between the front and rear vents of the display as this will affect the
efficiency of the refrigeration system.
Shelf Height Adjustment (High Capacity Only)
The height of the three glass shelves can be adjusted to suit your requirements. The
brackets can be relocated into any of the vertical slots to obtain the required shelf
height. Please ensure they are located correctly before loading the shelves.
All refrigeration systems frost up when operating. Your appliance has a microprocessor
control, programmed to defrost periodically. No manual defrost is required. The
refrigeration system will automatically defrost every 2 hours for approximately 20 minutes.
The controller will display ‘df’ during the defrost cycle. Water collected from the defrost
operation is automatically evaporated.
Please remember the refrigeration system is not designed to chill food, but is designed to
maintain it at a satisfactory temperature before serving.
GANTRY (Where purchased)
The gantry will be fitted with a fluorescent tube, this is controlled by an on/off switch on
the rear of the gantry, which enables the lamp to be switched on or off. The lamp is
replaceable. Please proceed as follows:
Replacing Fluorescent Lamp:
(a)
Turn off power to the unit. If the bulb has just failed it may be HOT.
(b)
Grip the bulb at both ends, near the connectors and twist the bulb approximately
90
o
.
(c)
Gently pull the bulb out of the connectors.
(d)
Reverse this process to fit, ensuring that the bulb is held firmly and correctly within
the connectors before releasing.
4. CLEANING
SWITCH OFF THE UNIT AT THE MAINS BEFORE CLEANING.
Stainless steel surfaces will give you many years of trouble-free use as long as you follow a
few simple rules. If it appears to mark do not worry, it is usually not the steel but
something deposited on it which has stained.
