www.viCtorstanley.CoM
CM-324
GreenSite SerieS™
fM-324
fraMerS Modern™ SerieS
aSSeMBly inStruCtionS
paGe 8 of 9
© Copyright 2009 Victor Stanley, Inc. All Rights Reserved
Should you have any problems, please contact Victor Stanley, Inc.
steP #11
#12
Next, install all bench slats using the supplied hardware. Make sure
the pre-drilled pilot holes are facing down and insert lag screw from
rear (As shown in Figure B). Hand tighten only.
Once the slats are attached and aligned properly, tighten the front
and back slats in an alternating sequence. (Front Right, Back Left,
etc.) Tighten all screws with tool.
do not oVer tiGhten.
hand tiGhten
tool tiGhten
For this step
use lag screw
combination
(parts D & E)
as shown:
Use provided
tool for step 11
Figure B
