I-VIC300MS
/ Vic-300
®
MasterSeal
™
Butterfly Valves
/ Installation and Maintenance Instructions
TAMPER-RESISTANT HANDLE KIT INSTALLATION
FOR 2 – 6-INCH/60.3 – 168.3-MM VALVES WITH
10-POSITION HANDLES
WARNING
• Read and understand all instructions before
attempting to install any Victaulic accessory
kits.
Failure to follow all instructions could result in
serious personal injury and/or property damage.
WARNING
• THE PUMP MUST BE SHUT OFF to
prevent flow from passing through the
valve during the following procedures.
Failure to follow this instruction could cause product failure,
resulting in serious personal injury and/or property damage.
The tamper-resistant handle kit can be installed without removing
the valve from the piping system .
THE PUMP MUST BE SHUT OFF
to prevent flow from passing through the valve during the following
procedures .
CONTENTS OF TAMPER-RESISTANT HANDLE KIT
Item No.
Qty.
Description
1
1
Tamper-Resistant Handle
2
1
Plate
3
2
Round-Head, Square-Neck Bolt (1/4 – 20 UNC x 3/4-inch Long)
4
4
Spring Washer
5
1
Tamper-Resistant Nut
6
2
Lock Washer (1/4 inch)
7
2
Hex Nut (1/4 – 20 UNC)
8
2
Self-Clinching Nut (5/16 – 18 UNC)
9
2
Breakaway Security Bolt (5/16 – 18 UNC x 3/4-inch Long)
10
1
Detent Screw
11
1
Washer
12
2
Memory Stop Washer
TAMPER-RESISTANT HANDLE ASSEMBLY DRAWING
1
2
3
4
5
12
7
6
Valve
Body
8
9
11
10
Exaggerated for Clarity
1 . Place the disc in the fully-open or fully-closed position .
2 . Remove the handle assembly by following the “10-Position Handle
Removal for 2 – 6-inch/60 .3 – 168 .3-mm Valves” section .
3 . Install the plate (Item 2) over the stem assembly and onto the valve
body mounting flange . Make sure two holes in the plate align with
two holes in the valve body mounting flange .
NOTE:
If the plate
is installed incorrectly, it will not seat evenly on the valve body
mounting flange .
Self-Clinching
Nuts (Item 8)
4 . Apply Loctite 262* (or equivalent) to the two breakaway security
bolts (Item 9) . Insert a breakaway security bolt (Item 9) through
the two holes in the valve body mounting flange and into the plate
(Item 2) where the self-clinching nuts (Item 8) are pressed into the
plate (Item 2) . Hand-tighten the breakaway security bolts (Item 9) .
* Loctite is a registered trademark of the Henkel Corporation and 262 is a
trademark of the Henkel Corporation
I-VIC300MS_14
victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY. © 2014 VICTAULIC COMPANY. ALL RIGHTS RESERVED.
REV_F
