LOWER ROLL REMOVAL
WARNING
• Always disconnect the tool from the
electrical source before making any tool
adjustments.
Accidental startup of tool may result in
serious personal injury.
The lower roll must be removed before the
upper roll.
Hydraulic
Pump
Valve
1.
Open the hydraulic pump valve by turning
the knob counterclockwise . This will raise the
slide and upper roll to their highest positions .
WARNING
• DO NOT strike the lower roll/
main shaft with a hammer or
other blunt object.
Striking the lower roll/main
shaft can cause fragmentation,
resulting in serious personal
injury.
2.
To remove the lower roll from the arbor,
loosen the lower roll retaining nut until it
reaches the end of the lower shaft . Do not fully
remove the nut .
NOTE:
Lower roll retaining nut in above
photograph has been fully removed for visibility .
Place the aluminum wedge (supplied with the
tool) behind the lower roll, then strike the wedge
with a soft-faced hammer to break the roll loose
from the arbor .
DO NOT STRIKE THE ROLL
DIRECTLY WITH A HAMMER.
Once the lower roll is loosened, remove the
lower roll retaining nut and lower roll . Store the
lower roll in a safe location for future use .
16
REV_B
TM-RG3212
/ Operating and Maintenance Instructions Manual
