7
4.
Raise the drill motor to its highest position
by rotating the feeder knob counterclockwise.
5.
Take the hex-shaped end of the arbor
assembly, and insert it into the chuck of the
drill’s motor.
6.
Support the arbor assembly, while tighten-
ing the chuck securely with the chuck key pro-
vided.
7.
Align the hole saw’s drill bit with the center
punch mark.
8.
Using the vise handle, tighten the chain
around the pipe to secure the hole-cutting tool.
9.
Check the switch on the underside of the
drill motor’s handle. Make sure the switch is in
the “forward” position, as shown above.
10a.
Install cord by aligning connector’s key-
ways. Push connector in as far as it will go.
Turn the cord’s nut
¹⁄₄
-turn to the right to lock
the cord in place.
• To reduce the risk of electric
shock, check the electrical
source for proper grounding,
and follow the instructions
below.
Failure to follow these instructions could result in
death or serious personal injury.
Switch –
shown in
forward
position
Trigger
HCT908
