5
2 stroke
FITTING THE HANDLE
1 Remove the two handle mounting screws from
their position in the chassis using the supplied
screwdriver.
2 Insert the handle tube into the chassis, as shown.
3 Fit the two stop switch/cable covers.
4 Fasten the handle fi rmly in position by inserting
the two supplied screws and tightening using the
supplied screw driver.
5 Make sure the cables are placed in the space of
the covers.
NOTE: DO NOT OVER TIGHTEN
Insert upper
shaft into
housing
Locking
collar
ATTACHING THE VACUUM BAG
1
Place the bottom of the bag frame in the supports on the rear of the chassis.
2
Depress and hold the yellow part of the bag handle to retract the bag latch.
3
Bring the bag frame into position.
4
Release the yellow part of the bag handle to engage the bag latch.
5
Unclip the locking collar from the handle and slide it down the handle tube. Clip the
locking collar to the top of the bag frame to lock in position.
Not
for
Reproduction
