Victa 2690990, Руководство оператора

Страница: 24 / 54

24
Check Mower Blade Stopping Time
Mower blades and mower drive belt should come to a com-
plete stop within fi ve seconds after the blade rotation con-
trol is disengaged.
1. With tractor in neutral, blade rotation control disen-
gaged, and operator in seat, start the engine (see
Start the Engine ).
2. Engage the blade rotation control and wait several sec-
onds. Disengage the blade rotation control.
3. If mower drive belt does not stop within fi ve seconds,
see an authorized dealer.
Clean the Battery and Cables
1. Pull seat up to access the battery and cables (see Fig-
ure 14),
2. Remove mounting hardware and disconnect negative
cable from battery.
3. Remove mounting hardware and disconnect positive
cable from battery.
4. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner.
5. Reattach the battery cables, positive cable and mount-
ing hardware fi rst, then the negative cable.
6. Push the seat down.
Change the Oil
Used oil is a hazardous waste product and must be dis-
posed of properly. Do not discard with household waste.
Check with your local authorities, service center, or dealer
for safe disposal/recycling facilities.
Remove the Oil
1. With engine o ff but still warm, disconnect the spark
plug wire ( D , Figure 8) and keep it away from the
spark plug.
2. Remove the dipstick (
A ).
3. Remove the oil drain cap as shown in Figure 15. Drain
the oil into an approved container.
4. After the oil has drained, install the oil drain cap.
Battery Maintenance
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order, the
positive terminal can be shorted to the frame by
a tool.
WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds - chemicals known to
the State of California to cause cancer, birth defects, or
other reproductive harm. Wash hands after handling.
A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the cause
of the problem, see your dealer. If you need to replace the
battery, see the Clean the Battery and Cables section.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the Operator Safety section of this manual.
Charge the battery until fully charged. Do not charge at a
rate higher than 10 amps.
WARNING
Keep open fl ames and sparks away from the bat-
tery; the gasses coming from it are highly explo-
sive. Ventilate the battery well during charging.
Charge the Battery
Not
for
Reproduction