Vicon VN-NVR Shadow, Инструкция по установке и эксплуатации

Страница: 11 / 34

10
|
ViconNet VN-NVR Shadow Installation and Configuration Guide
Step 2: Connecting the Hardware
This procedure describes the various hardware connections that must be
performed in order to operate the system.
1. Perform the following connections: (refer to Rear Panel diagram).
1.1 Locate the keyboard on a flat surface near the unit. Connect the
keyboard by inserting its connector into the correct port.
1.2 Locate the mouse on a flat surface near the unit. Connect the mouse by
inserting its connector into the correct port.
1.3 Position the monitor in a permanent fixed location near the unit. Connect
the monitor by inserting its connector into the appropriate Monitor Output
port.
1.4 Insert one side of a standard LAN cable to the Network Port’s RJ-45
connector (NIC 1). Insert the other RJ-45 connector into the LAN side of
the network.
1.5 Connect external hardware devices to the relevant terminal.
1.6 Insert the female end of the provided 120 VAC power cable into the unit's
power receptacle. Do not connect the remaining end to a power
receptacle until instructed. If using 230 VAC power, it is necessary to
obtain a suitable power cord for use. This cable is a standard computer
230 VAC power cord.
2. Connect the monitor to the power source and power on.