Vicon VN-NVR Shadow, Инструкция по установке и эксплуатации

Страница: 10 / 34

ViconNet VN-NVR Shadow Installation and Configuration Guide
|
9
Installing the VN-NVR Shadow
After the unit is mounted permanently, follow the steps in this section to
install the hardware.
•
Step 1: Installing the Drives
•
Step 2: Connecting the Hardware
•
Step 3: Connecting the Power Supply
Important Notes
Do not apply power or plug-in the unit to any outlet until instructed to do so.
Disable the AC power to prevent installer injury and damage to the unit.
Before beginning the hardware installation, ensure that the room or area
designated for the
ViconNet hardware installation is well ventilated.
Step 1: Installing the Drives
The NVR Shadow is delivered with the 8 RAID drives packaged in the
accessory kit. Each of the drives (8) must be installed into the unit in the
correct bay for proper operation. Refer to the Front Panel figure for Bay
numbers.
Caution
The RAID drives are configured at the factory and have to be installed back
into the correct bay.
Push the lock button to release the arm on the drive. Insert each tray into the
corresponding bay number. Secure the arm back into place.
Caution
Make sure that the serial number on the tray matches the serial number on
the VN-NVR Shadow. Each tray has a label indicating the serial number and
the bay number.