Vicon VN-301TV5, Руководство по установке и эксплуатации

Страница: 14 / 35

Mounting
There are two types of mounting recommended for the encoder as shown below.
Desktop
The VN-301TV5 can be mounted to a clean and dry desk or tabletop. It can rest on the flat surface or
fastened using the provided mounting plate. In addition, there must be an area of no less than 3 in. (76 mm)
left around the exterior to provide suitable airflow for cooling. Do not place items on the cover.
Rack
The VN-301TV5 can be mounted in a standard 19-inch (483 mm) wide vertical rack shelf. The shelf is not
provided. The server can be rested on the shelf or fastened using the provided mounting plate.
Installing the VN-301TV5
After the encoder is mounted permanently, follow the steps in this section to install the server unit hardware.
Step 1: Connecting the Cabling
Step 2: Connecting the Power Supply
IMPORTANT NOTES:
The connection of external hardware may require simple hand tools.
WARNING: Disable the AC power to prevent installer injury and damage to the unit.
Before beginning the hardware installation, ensure that the following environmental conditions have been met:
•
The surface on which the VN-301TV5 is to be placed must be level, clean and dry.
•
The room or area temperature is climate controlled for human occupancy.
Step 1: Connecting the Cabling
This procedure describes the required cabling that must be installed in order to use the encoder.
To connect the cabling:
Perform the following connections (refer to Figure 3-1):
1. Insert one side of a standard LAN cable to the Network Port’s RJ-45 connector. Insert the other RJ-45
connector into the LAN side of the network (hub, switch, wall jack, etc.). Verify that a PC computer or
ViconNet workstation is available for software configuration.
2. Locate the camera video input cable near the server. Insert the BNC-M plug into the encoder’s BNC-F
Video (Camera) Input port.
6
•
Chapter 3 - Installation XX159-06-05 Rev 1208 VN-301TV5 Single-Channel Digital Video Server