4
••
Installation
XX068-10-00 Rev 1100 VM614RK-2
Table 1
Accessory Kit
Component
Quantity
Function
7 x 3/4 type AB screw
4
Fastens baseplate to monitor
6-32 x 1/4-in. pan head screw
(black)
4
Fastens front bezel to rack mount
6 x 1/2-in. self-tapping pan
head screw
10
Locks baseplate to side supports, attaches
extension plate to baseplate and bracket to
extension plate
Bracket
2
Fastens monitor to extension plate
Assembling the Baseplate to the Monitor
To assemble the baseplate to the monitor, use the following procedure. Refer to Figure 1 and 2 as needed.
1. Attach the extension plate to the baseplate with four (4) 6x1/2 self-tapping screws. Secure the brackets to
the extension plate with the 6x1/2 self-tapping screws. Refer to Figure 2.
2. Turn the monitor upside down on a clean, flat workspace.
3. Attach the baseplate/extension plate to the monitor base, using the 7 x 3/4 screws at the two sets of holes
toward the front and rear of the monitor base. Refer to Figure 2.
Assembling the Side Supports to the EIA Rack
The right and left side support brackets (gussets) mount directly to the EIA rack. Refer to Figure 1.
1. Position the side supports so that there is enough clearance to attach the front panel (bezel).
2. Attach each side support to the rack using three screws compatible with the rack’s screw holes. These
screws are not included in the accessory kit.
Assembling the Monitor/Baseplate to the Side Supports
The baseplate/extension plate has two tabs bent down on each end. Note that each side support has two
corresponding slots. Refer to Figure 1.
1. Carefully lift the monitor/baseplate assembly into position between the side brackets, with the front of the
monitor facing the front of the rack. Position the monitor/baseplate assembly so that the tabs on the
baseplate go into the slots in the side supports. Take care that all four tabs are properly seated.
