The VC-700W can be either mounted to a surface (like a ceiling or
wall) or installed into the ceiling, with or without an electrical box.
1 Use the large (Torx T20) L-Wrench to loosen the 4 screws (B) securing
the dome assembly.
2 For surface-mount installations, align the mounting base (D) with the
mounting surface; mark the mounting screw holes and then drill the four
holes. For in-ceiling installations not mounting to a 4x4 electrical box,
mark the holes in the camera assembly (C) and then drill the holes. For
in-ceiling installations, (D) is not used.
3 For in-ceiling installations, cut a hole (diameter: 2.9 in./73 mm) in the
ceiling for routing the cables.
4 Route the power cable(s) and video cable(s) to the installation location.
5 Align the four mounting holes in (D) with the holes in the ceiling.
Using the four screws and anchors provided (G), if appropriate for
mounting surface, fasten the mounting base to the wall/ceiling. Using the
other four screws provided, secure the camera assembly (C) to the
mounting base. For in-ceiling installations, align the holes in (C) with
the holes drilled in the ceiling and secure the camera assembly with the
hardware provided, if appropriate. If installing to an electrical box, secure
(C) with the screws provided.
6 Pass the power cable (E) and video cable (F) from the camera unit
through the cable hole in the ceiling. For surface-mounted units, cabling
is routed through the knockout hole in the side of the unit.
7 Carry out the settings and adjustments for the camera previously
described.
8 Secure the dome assembly (A) by tightening the screws (B).
