4
••
Installation
X610 Rev 399 V1512MM-A
11. Turn the monitor on its back and fit the monitor mount around it, attaching the lower mount member to the U
channels using the 1/4-20, 5/8 inch long screws and flat washers provided. Do not fully tighten the screws.
12. Adjust the mount for proper tilt angle and tighten tilt control knobs. Move the monitor forward and backward
until proper balance is achieved and tighten the channel screws.
13. Slide the side members of the mount in until the rubber strips on the side supports are firmly against the
monitor. Tighten the large pan head screws on the top member.
If the unit is being mounted to the V1512WM, attach the V1512MM-A with the 5/16 x 1-1/2 inch bolt, lock
washer and nut provided with the V1512WM. Place the two 1-3/4 inch spacers provided with the V1512MM-A
between the L bracket and the monitor.
If the unit is being mounted to a rigid overhead support, continue through step 15.
14. Determine the material of the overhead support. If it is wood, drill a 7/32-inch pilot hole in the overhead
support. If the overhead support is concrete, install a 5/16 lead screw anchor. If the support is steel, drill an
11/32-inch hole.
15. Fasten the monitor and mount assembly to the overhead support with the appropriate hardware, 5/16 x 2-
inch lag screw for a wood or concrete support or a 5/16-inch bolt of suitable length with washer, lock washer
and nut for steel support.
This completes the assembly of the VM5123 monitor and the V1512MM-A monitor mount.
Figure 2
Installing the VM5123 in the V1512MM-A
