2
••
Installation
X610 Rev 399 V1512MM-A
Installing the V1512WM
The V1512WM may be mounted from either a wall or a ceiling in two possible arrangements. Refer to Figure 1 to
determine which configuration is appropriate for the installation. Position A is used most often.
Installing in Position A
Attach the adapter to either the wall or ceiling using 5/16 x 2-inch bolts or lag screws. If the structure has a
wood frame, the lag screws must be screwed into wall studs or ceiling joists. If the mounting surface is masonry
or concrete, use lead anchors for the lag screws. If the V1512WM has been ceiling mounted, attach the short
right-angle bracket with a 5/16 x 1-inch bolt, lock washer and nut.
Installing in Position B
Remove the strut completely from the L bracket before mounting the L bracket to the wall or ceiling. In wall
installations, allow enough room above the L bracket for the strut. Mount the L bracket as shown for position A
and loosely attach the strut to it. Bolt the strut to the wall or ceiling with 5/16 hardware and tighten the screw
holding the strut to the L bracket. If the V1512WM has been ceiling mounted, attach the short right-angle
bracket with a 5/16 x 1-inch bolt, lock washer and nut.
Ceiling Installation
Wall Installation
Figure 1
Installation of the V1512WM Mounting Adapter
