Vicon V1411X-DVC, Руководство по установке и эксплуатации

Страница: 11 / 16

6
•
Operation XX074 Rev 101 Variable-Speed Keypad
Operation
Operating Modes
Accessing Operating Modes
5 0
...
Press the appropriate
number key. Press & Hold
PROG
Release
PROG
Mode Description
Normal operating mode
Preset Store mode.
Set Dwell mode.
Setup mode. 1
2
3
4
Alarms
Acknowledging Alarms
Viewing Alarm Video
For control systems with an independent stack
mode, press ALARM again after all alarms are
cleared from the currently-selected alarm
monitor. This will select the next alarm monitor
if it has active alarms. Continue with the alarm
acknowledgment procedure to clear alarms.
To view but not acknowledge
alarms, press CANCEL or SEQ
to step through active alarms. SEQ will step you through the
alarms from the first active
alarm to the last active alarm. CANCEL will step you through
the alarms from the first active
alarm to the last active alarm.
If ALARM flashes in the display
window, press ALARM to view
the alarm video. (If alarms are
sequencing, the first press of
the ALARM key will stop the
sequencing.) If ALARM continues
to flash in the display
window, press
ALARM until all
alarms are cleared.
Press
ALARM to
clear the
alarm.
Notes: If the currently-selected monitor is not defined as an alarm monitor, press ALARM before performing the procedure below in
order to select the lowest numbered alarm monitor. Monitors are defined as alarm monitors as discussed in the programming
manual for your control system.
ALARM
CANCEL SEQ
OR
Auxiliary Function Control
Controlling Auxiliary Functions
Which auxiliary functions are momentary
and which are latching depends upon
your receiver. Refer to your receiver
documentation if necessary.
Momentary functions
stay active as long as
the number key is
pressed. To activate latching
auxiliary functions,
press an AUX key
and release.
9
1
...
Press
Enter aux number
AUX
Communication Failure
Press
CANCEL
If the com fail is on a
camera that is NOT
currently selected,
COMFL and a block
caret will flash.
This selects the
camera having
the com fail.
Press
CANCEL
This acknowledges
the failure.
If the com fail is on
a camera that IS
currently selected,
COMFL flashes.
Press
CANCEL
This acknowledges
the failure.
Mode 1 is automatically entered
after power is applied or if the
keypad is reset. Refer to
Indicators in Display in the
Technical Information chapter for
LCD status messages.