Vicon SurveyorVFT, Быстрое руководство, Страница: 18 / 25

Preset 97 (Initiate Dome Reset) — Storing preset 97 resets all of the system software and performs the
power-on self-test. This is called a “soft reset” because no memory settings are affected. All user
programmed options such as titles and presets remain unchanged. Recalling preset 97 has no effect.
Preset 98 (Programming Autopan Limits) — When a SurveyorVFT is selected on a keyboard, pressing
the AP (autopan) key will start the camera in motion, panning at a predetermined speed.
•
To change the speed — Press and hold the AP key while moving the joystick to the desired speed.
When the speed is correct, release the AP button and then the joystick. Each dome may have its
own autopan speed and pressing the autopan key will start the dome panning at the last speed
selected for that dome. (When using a Kollector DVR, shut off AP, move the slider to desired speed
and press AP again.) In continuous rotation only, the autopan command will cause the dome to
reverse direction.
•
To stop autopanning — Any other pan command will disable autopan. This includes pressing the
AP key again, panning the camera with the joystick, or recalling a preset.
•
To set the autopan limits — When a continuous rotation dome is in autopan, it will rotate in a full
circle until autopan is disabled. When an application, such as a wall-mounted camera on a building,
does not require continuous rotation, limits are set to define the left and right boundaries. Storing
preset 98 will bring up a series of prompts to set the left and right autopan limits with the AUX 2 and
AUX 3 keys. When the autopan limits are set and the camera is placed into autopan it will pan until
it reaches a limit. It will then reverse direction until it reaches the opposite limit, repeating this cycle
indefinitely.
To clear the autopan limits — Store preset 98. Press AUX 2 and AUX 3 without panning to set the
autopan limits to the same position. By recording both limits on the same point they will both be deleted.
The dome will now rotate continuously when placed in autopan mode until new limits are programmed.
Recalling presets 98 has no effect.
Preset 99 (Set Manual Pan Limits) — Storing preset 99 will bring up a series of prompts to set the left
and right manual pan limits with the AUX 2 and AUX 3 keys. After these are set, the physical range
between these limits is the valid range. The camera dome will not move outside these limits. Setting pan
limits also sets AP limits if the AP limits are outside the of the pan limits. The only exceptions are
prerecorded tours and previously stored presets. To clear the pan limits, press AUX 2 and AUX 3 without
panning.
Programming Menus
The Main Programming Menu is the first one seen when entering
programming mode (store preset 94). Subsequent menus, called sub-
menus, are accessible from this point. When in programming mode, a
function is entered by pressing the
AP (autopan) key. To back out of that
function without changes, press the AI (autoiris) key. Instructions are
available on the screen for almost all functions. Since many of the
menus available on the SurveyorVFT are similar, not all are shown here. For convenience,
press the L-SPD (lens speed) button to display a black background.
The selections available on this menu can be summarized as follows:
System Settings — Allows the user to adjust the speed of the pan and tilt axes. Solving preset
positions is always done at full speed. This menu also controls the Zoom Scalable Pan/Tilt,
Compass, PTZ Timeout, Address Setting, Flip, Fan Speed, and Privacy Mask Zoom Level
features (Frame Noise Reduction and CCD mode on certain models).
Camera Controller — Permits user adjustment of the advanced video features available on the
SurveyorVFT .