5
2.1.1 Wall Mounting
The wall mounting plate must be attached to a structural object such as concrete that will support
the weight of the mount and dome camera.
1.
Select a suitable mounting location and verify there is sufficient cable to reach the middle
of the Wall Mount.
2.
Mark and drill mounting holes in the surface using the wall mount flange as a template.
3.
Secure the mounting plate to the wall using the hardware provided or appropriate for the
mounting surface.
4.
Pull out cables required to connect to the dome camera from the wall or route cables
through a section of 0.75 in (19 mm) conduit pipe.
5.
Remove the cable access plate from the underside of the wall mount bracket.
6.
Attach the wall mount bracket using plastic anchors and M8x35 screws; route cables
through the access plate hole.
7.
Attach the 1.5 inch adapter to wall mount bracket and fix it using set screw.
8.
Attach the camera’s safety wire to the wall mount’s latch.
9.
Route cables on the dome through the wall mount bracket. Fix the housing to the wall mount
bracket using the locking nut and tighten the housing set screw with the supplied wrench.
10.
Reattach the access plate.
11.
Push in and turn the camera clockwise into the adapter and fix it using set screw of the
adapter.
