Vicon S2000-UPM, Инструкция по установке и эксплуатации

Страница: 6 / 11

2
••••
Installation XX038 Rev 300 S2000-UPM Parapet Mount
TABLE 1
MOUNTING KIT COMPONENTS
Item No. Component Quantity Function
1 Wall bracket 2 Secures parapet
mount to mounting
surface
2 Wall bracket cover 2 Secures parapet
mount in wall
bracket
3 Support bracket 1 Secures bottom wall
bracket
4 Cap 1 Closes off bottom of
mount but allows
cabling to be routed
5 5/16-18x1 in. screw 4 Secures wall bracket
cover
6 5/16 lock washer 5 Secures item 5 and
8
7 5/16x5/8x0.062 flat
washer 5 Secures item 5 and
8
8 5/16-24x3 in. bolt 1 Prevents parapet
mount from spinning
9 5/16-24 nut 1 Secures item 8
10 Coupling (optional*) 1 Joins parapet mount
and parapet neck
11 Set screw 2 Secures item 10
12 Teflon tape 1 Seals pipe thread
13 Reducer coupling 1 Reduces the
diameter of the pipe
to accommodate the
S2000 housing
14 Nipple 1 Secures housing
*Some units may be shipped as one piece, eliminating the need for the coupling.
Note: The S2000-UPM is designed to support the weight of the Surveyor2000 Camera Dome. Refer to the
appropriate product specifications for the weights of these dome systems. Be sure that the mount is
installed in a location that can support the load. There should be a minimum parapet height of 18 inches
(46 cm).
Note: For outdoor installations, it is recommended that stainless steel hardware be used. All mounting
hardware MUST have a minimum pullout strength of 600 lb (272 kg) per bolt. When mounting to wood,
use screws long enough to penetrate at least 2.5 inches (6.4 cm). If mounting to a steel structure, drill
holes according to the mounting pattern. Screws should be long enough to accommodate lock washers
and nuts. In masonry or concrete, use lead anchors or expansion bolts installed according to the
manufacturer’s instructions.
Caution: Never mount the brackets directly into the end grain of wood.