Vicon NOVA V1400X-HSB-M, Инструкция по эксплуатации

Страница: 13 / 28

6
•
Installation XX018 Rev 200 NOVA V1400X-HSB-M
Titler Connections
Connect the cables between the Primary and Secondary V1400X-
TC-M CPUs and the V1400X-TSO module as shown in Table 2.
Instead of using Table 2, Figure 5 may also be used.
Prepared cables may or may not be supplied in the accessory pack,
depending on the particular system configuration. If they are not in
the accessory pack, the pack will contain the necessary mating
connectors to allow the installer to make his own cables. If the cables
must be assembled by the installer, connect pin 1 on the Primary
system’s end of the cable to pin 1 on Secondary system’s end of the
cable, pin 2 to pin 2, and so forth.
Note: If you assemble the cables for these connections, note that the
cables must be shielded using the connector shells.
Table 2
Connections to V1400X-TSO Titler Module
V1400X-TSO Connector No. Connects to:
J1 TDT cages for outputs 1-64
J2 J2 on Primary V1400X-TC-M
J3 J2 on Secondary V1400X-TC-M
J4 TDT cages for outputs 65-128
J5 J3 on Primary V1400X-TC-M
J6 J3 on Secondary V1400X-TC-M
J7 - J12 unused