Vicon Kollector Fore, Руководство по установке и эксплуатации

Страница: 18 / 44

Chapter 3
Installation
For novice or first-time installers, these steps provide the most thorough and accurate instructions.
About This Chapter
This chapter details the complete installation of the Kollector Digital Video Recorders. The following sections
provide information as follows:
•
Unpacking the Recorder defines how to remove the unit and accessories from the box.
•
Required Items for Installation defines items needed for installation.
•
Unit Components defines all connections on the front and rear panels and their use.
•
Mounting defines all methods of securing the recorder for permanent use.
•
Installing the Kollector describes how to install all necessary peripheral devices directly to the recorder.
Unpacking the Recorder
Carefully open the carton. Remove the accessory kit and the recorder from the box and place them on a
large, flat working surface. Open the accessory kit and verify the contents against the list in Table 1-1, page 2.
For some Kollector Strike units, the 4 hard drives, including the OS drive and 3 additional drives, are
configured at the factory but are not shipped installed in the unit. Follow the instructions included with the
drives to install them into the correct slot.
Required Items for Installation
To properly install the recorder there must be simple hand tools available such as a screwdriver, wrenches,
pliers and wire cutters/strippers. To setup the recorder for operation there must be a keyboard and a mouse
available to operate the GUI. These are included with the Kollector unit.
8
•
Installation XX112-06-01 Rev 911 Kollector Network Digital Video Recorders