Vicon I-Onyx MP-955, Руководство по установке и эксплуатации

Страница: 8 / 36

2
Installation
Connectors and Controls
Reset Button
Rear Panel
1. Ethernet Port
The camera connects to the Ethernet via a standard RJ-45 connector. Supporting NWay
(auto negotiation), this IP camera can auto detect the speed of local network segment
(10Base-T/100Base-TX Ethernet). The camera supports PoE, so it can be powered through
the Ethernet port as well.
2. Reset Button
To reset the camera back to factory defaults, follow the steps below:
Step 1: Switch off the camera by disconnecting the power cable.
Step 2: Press and continue to hold the reset button. Reconnect the power cable while
continuing to hold the reset button.
Step 3: Keep holding the reset button depressed about 6 seconds and then release it. The
unit will start up with factory default settings.
3. Audio Input/Output
Not supported by ViconNet (for future use).
4. Action LED Indicator
The LED will light up after IP camera has successfully completed the boot process.
XX194-00-03 Rev 110 MP-955 Series Megapixel Camera