30
Road transport
Prior to road
transport
The transport position must be used for driving on the road. The fol-
lowing steps are necessary to bring the implement into the transport
position:
> Remove any crops and coarse dirt.
> Reset the field cleaning.
> Release the running wheel latch.
Resetting the angled
position
Resetting the angled position before road transport
Before the implement is folded into the transport position, ensure that
the limit area position is not set. Damage may be caused to the imple-
ment.
> Release the securing pins on the side equipment steering rods.
N
OTE
The bolts in the illustration show the position of the securing pins for
the reset angled position. This position must be set on both sets of
side equipment.
> Swivel both sets of side equipment with the control lever for the an-
gled position until the securing pins are engaged in the required
position.
Release the running
wheel latch
Release the running wheel latch
Before the implement is folded into the transport position, ensure that
the running wheels are not locked. Damage may be caused to the im-
plement.
> Raise the securing pins for all running wheels and engage them in
the recesses.
The running wheel latch for all wheels is released. The caster function
for all running wheels is available for use.
→
See also »Securing the running wheel latch«, page 36
Steering rod
Securing pins
Side equipment
Control lever for the angled position
Recess
Securing pins
