5
Perform the following steps when using the O2
Top Cover
These steps correspond to the installation
images 1 – 6 on the Quick Installation Guide:
• Check cushion size. Width (X) of the cushion
and seat should match. When the cushion
rests against arm supports or side-guards,
the width may be up to 2.5 cm (1”) wider.
Depth (Y) of the cushion and seat should
match.
• Check if the size of the cover matches the
size of the cushion.
• Remove protective backing tape from self-
adhesive hook strips attached to the bottom
of the cushion.
• Place cushion by pressing firmly.
• Place the O2 Top Cover over the top of the
cushion.
• Pass the loop at the back of the cushion
through the ‘button hole’ in the back of the
cover.
• Sit on the cushion for a few minutes, to
allow the cushion to adapt to your body
shape.
• If necessary, adjust foot supports.
Alternative cushion covers
Perform the following steps when using the
Comfair Cover, Incotec Cover or Reversible
Cover.
Please note: The Reversible Cover is delivered
with the cool breathable side on the outside. If
you require the fluid-resistant side of this cover:
first unzip the top section of the cover
completely from the bottom section, turn top
section inside out and rezip it to the bottom
section.
• Check cushion size. Width (X) of the cushion
and seat should match. When the cushion
rests against arm supports or side-guards,
the width may be up to 2.5 cm (1”) wider.
Depth (Y) of the cushion and seat should
match.
• Check if the size of the cover matches the
size of the cushion.
• Remove the hook strips from the bottom of
the cushion. Note that the strips confected
to the bottom of the cushion cannot be
removed.
• Insert cushion in cover.
• Pass loop through eyelet in cover.
• Close zipper. Make sure to not damage the
cushion.
• Remove protective backing tape from self-
adhesive hook strips attached to the cushion
cover.
• Place cushion by pressing firmly.
• Sit on the cushion for a few minutes, to
allow the cushion to adapt to your body
shape.
• If necessary, adjust foot support.
Checking for “bottoming out”:
Image 7 - Quick Installation Guide
Warning!
Your tailbone and pelvic bones should
not touch the bottom of the cushion. Checking
for “bottoming out” should be done during first
use and after adjustments to the cushion filling.
Warning!
Vicair B.V. recommends to adjust the
filling grade under the direct supervision of
your therapist or Assistive Technology
Professional.
• Check for bottoming out, after sitting on the
cushion for approximately 5 minutes.
• Let your therapist or Assistive Technology
Professional slide a hand between your
buttocks and the Vicair cushion while
leaning forward.
• Ask your therapist or Assistive Technology
Professional to check if your lowest bony
prominences are supported by at least 2,5
cm / 1” of SmartCells. This prevents them
from touching the wheelchair seat.
• Do not use the cushion if bottoming out
occurs. In most cases, adjusting the filling
grade of the compartments will solve the
problem.
Содержание VECTOR O2
Страница 1: ...USER MANUAL...
