Vibe DELTABOX BASS GENERATOR, Руководство пользователя

Страница: 6 / 12

Set up guide
Main input / Aux input
Set the SUB LEVEL control to the minimum setting.
Set the CROSSOVER control to the desired frequency. This will vary depending on the type of subwoofer system that
have. As a rough guide if you prefer deep bass set the frequency between 40Hz – 60Hz, and 80Hz – 120Hz for
punchy bass.
Set the volume level of the source to around 3/4 or just below the point of the speakers beginning to distort.
Slowly rotate the SUB LEVEL control until either the desired subwoofer level is reached or just below the point of
distortion
NOTE : As there is likely to be a difference between the level of an auxiliary source and the main input, it may be
necessary to alter the SUB LEVEL control for each source.
Bass Boost
Set the BASS BOOST level control to the minimum setting.
Set the BASS BOOST frequency control to the desired frequency. To add more depth to the bass set the frequency
between 40Hz – 60Hz, to add more impact set the frequency between 70Hz – 120Hz
With music playing at full volume without distortion slowly rotate the BASS BOOST control until either the desired sound
is reached or just below the point of distortion.
Tone generator
The tone generator will play a single frequency tone at the push of a button – Bass on demand!
Set the TONE LEVEL control to the minimum setting.
Set the TONE FREQUENCY control to the desired frequency
With either the TONE GENERATOR select switch or BASS REMOTE pressed, slowly rotate the TONE LEVEL control until
either the desired level is reached or just below the point of distortion.
WARNING : The TONE GENERATOR level is unrelated to the main and AUX inputs, the level is set by the TONE LEVEL
control. Excessive use of the TONE GENERATOR will cause permanent damage to the subwoofer that will not be
covered by the manufacturers warranty.