Front panel
1. AUX input
Low level input that can be connected to IPOD / MP3 player / DVD player / games console via the supplied 3.5mm stereo
jackplug lead.
2. SUB level control
This control sets the subwoofer level for the main input.
3. Main / AUX input switch
This switch switches between main and AUX input.
4. Crossover frequency control
This control is used to set the low pass crossover point for the output.
The frequency can be adjusted from 40Hz to 400Hz.
5. Bass boost level control
This control provides bass boost at the selected frequency for the main input.
The level can be adjusted from 0dB to 12dB.
6. Bass boost frequency control
This control sets the frequency of the bass boost for the main input.
The frequency can be adjusted from 40Hz to 120Hz
7. Tone frequency control
This control is used to set the frequency of the tone generator.
The frequency can be adjusted from 30Hz to 300Hz
8. Tone level control
This control sets the level for the tone generator.
WARNING : The tone level control is in no way connected to the main input of the unit.
The level of the output of the tone generator is set by this control only and excessive levels will cause permanent damage to
your subwoofer which will not be covered by the manufacturers warranty.
9. Normal / tone generator select switch
This control switches between normal (main and AUX input) and tone generator.
NOTE : When this switch is pressed the normal operation will cease and the unit switches into tone generator mode.
10. Remote turn on output switch
This switch turns the +12 volt remote output on or off.
Rear panel
11. Main input RCA connection
For connection to the RCA outputs of your source (headunit).
VIBE recommends that the subwoofer output from the source is used where available.
12. Output RCA connection
For connection to the RCA inputs of the subwoofer amplifier.
13. Bass remote input jack socket
For connection to the supplied bass remote control.
14. Power connections
Ground – connect to the chassis ground of the vehicle.
Remote in – connect to the remote amplifier turn on wire of the source unit.
+12 volt in – connect to the positive terminal of the battery or an alternative per12 volt supply.
Remote out – connect to additional devices that require a sw12 volt supply.
Содержание DELTABOX BASS GENERATOR
Страница 8: ...Notes ...
Страница 9: ......