background image

Fully Charge Pocket Jump Before First Use

Batteries naturally discharge when not in use, so it is highly recommended to fully charge the device before first 

use. Check the capacity by pressing the capacity indicator button. If all 4 capacity indicator LEDs light up, then 

your Pocket Jump is ready to jump your vehicle. If not all capacity indicator LEDs light up, follow the instructions 

under the "Charging the Pocket Jump" section until the Pocket Jump is at full capacity. When not used regularly, we 

recommend a routine charge to full capacity once every 30-45 days. 

Jumping Your Vehicle

NOTE: Before use, make sure all of your vehicle's electrical accessories are turned off. The Pocket Jump must 

be fully charged to jump your vehicle. If your vehicle has not been started for an extended period of time and the 

battery is dead, it is likely that the battery is fully discharged and will not be able to be charged using Pocket Jump.

Step 1: Test the Battery. 

Without connecting it to the Pocket Jump, insert the cigarette lighter 

connector end of the cigarette lighter adapter into the cigarette lighter socket of your vehicle. 

Turn the key in the ignition to the accessory position, usually one-quarter turn of the key (for a 

vehicle with push-button start, push the start button without engaging the brake). If the power 

indicator LED lights up, continue. If not, your vehicle's battery may be damaged and unable to 

charge.

Step 2: Test Electrical System.

 Leaving the adapter plugged into your vehicle, turn on the 

headlights. Leave them on for 10-15 seconds. Turn them off. If the power indicator LED stays 

on, move to Step 3. If the LED turns off, your vehicle's electrical system may be damaged and 

professional help may be needed.

Step 3: Charging the Vehicle.

 Plug the cigarette lighter adapter's DC connector into the 

Pocket Jump's DC/car port. Pocket Jump will turn on automatically (capacity indicator LEDs 

will illuminate). The power indicator LED on the adapter will stay on, indicating power is flowing 

from the Pocket Jump into your vehicle. Wait 20 minutes. After 20 minutes have passed, 

disconnect the Pocket Jump from the vehicle. Disconnect the adapter from the DC/car port 

and Pocket Jump will shut off automatically in about 30 seconds. 

Step 4: Start the Vehicle.

 Start your vehicle without pumping the gas. Pumping the gas could 

cause engine flooding and prevent the vehicle from starting.

Charging Your Portable Devices

Plug your portable electronic device into either of the USB ports using your device's USB 

cord. Pocket Jump will turn on automatically (capacity indicator LEDs will illuminate) and begin 

charging your device. If it does not, press the capacity indicator button to begin charging. If 

charging two devices at once, connect the device with the greater battery capacity to the 2.1A 

USB port (Ex: Charging a tablet and mobile phone, charge the tablet via the 2.1A USB port) for 

best results. Consult your device's user manual for battery capacity/charge rate. 

AUTO-SHUTOFF FEATURE:

 Pocket Jump will automatically shut off in about 30 seconds 

once all portable devices are disconnected. 

Charging the Pocket Jump

Charge your Pocket Jump via USB power source with the included USB cord. Connect the 

micro USB end to the Pocket Jump's micro USB port. Then, plug the cord into a USB power 

source, such as a USB power port on a computer or a USB wall adapter (not included; many 

devices such as smart phones and tablets come with USB wall adapters). The charge indicator 

LEDs will start blinking and display the battery level. A full charge takes approximately 4-6 

hours. Once the Pocket Jump is fully charged, the charge indicator LEDs will stop blinking 

and display a full battery level (all 4 LEDs will light up). Disconnect the Pocket Jump and it will 

automatically shut off in about 30 seconds. 

DO NOT charge the Pocket Jump for more than 

6 hours.

 It is not recommended to use the Pocket Jump to charge electronic devices while the 

Pocket Jump unit itself is being charged.

IF YOU HAVE RECENTLY USED THE POCKET JUMP TO JUMP START YOUR VEHICLE: Wait until your vehicle is operating 

and running smoothly before charging the Pocket Jump via USB adapter in your vehicle. Do not leave the Pocket Jump 

plugged in to be charged by your vehicle while the vehicle is not running, as this may drain your vehicle's battery.

Press the capacity indicator button at any time to check the battery level. If the charge is at full 

capacity, all 4 capacity indicator LEDs will light up. If they do not, the Pocket Jump is not fully 

charged and must be charged before being used to jump start a vehicle. It does not need to 

be at full capacity to charge a portable electronic device. Pocket Jump will automatically turn 

on when it detects a connection to either the 2.1A or 1.0A USB port or to the cigarette lighter 

adapter and will automatically shut off in about 30 seconds once disconnected from either.

Содержание MJ10

Страница 1: ...R PORTABLE POWER BANK POCKET POCKET POCKET JUMP JUMP EMERGENCY VEHICLE JUMP STARTER PORTABLE POWER BANK POCKET POCKET JUMP Instructions for Use Model MJ10 Includes Pocket Jump cigarette lighter adapter and USB charging cord BUYPOCKETJUMP COM ...

Страница 2: ...flooding and prevent the vehicle from starting Charging Your Portable Devices Plug your portable electronic device into either of the USB ports using your device s USB cord Pocket Jump will turn on automatically capacity indicator LEDs will illuminate and begin charging your device If it does not press the capacity indicator button to begin charging If charging two devices at once connect the devi...

Страница 3: ...oring Disconnect all cords from the Pocket Jump to store You can store your Pocket Jump in your glove box console or trunk We recommend you do not store the Pocket Jump plugged in Store in temperatures of 10 F to 110 F If temperatures in the vehicle exceed this we recommend removing the Pocket Jump Cigarette Lighter Adapter Cigarette Lighter Connector DC Connector USB Cord USB Micro USB 2 1A USB P...

Страница 4: ...o bring a defective battery back up to a usable level The testing procedure where you simply insert the cigarette lighter adapter into your power port accessory cigarette lighter socket is designed to tell you if your vehicle battery will or can accept the charge before you begin the process If the power indicator LED does not light up your Pocket Jump will not work to charge your battery and your...

Отзывы: