Viatek CWC-302, Руководство пользователя

Страница: 4 / 8

USE INSTRUCTIONS
See parts diagram to aid in assembly
and operation.
BEFORE FIRST TIME USE
1. Remove all packaging materials.
2. Clean unit as outlined in the CARE
INSTRUCTIONS section of this manual.
3. Check unit for damage before each use. Do not
use if power cord or adapter is damaged or not
functioning properly.
INSTALLING FILTER
1. Attach filter onto peg inside top of unit (fig. 1 ).
Press firmly to ensure fully installed.
2. Install squeegee head over filter and onto unit,
(fig. 2) being sure squeegee is locked in place prior
to use.
CHARGING BATTERY
Attach adapter to unit using the charging port before
plugging adapter into a grounded outlet. Make sure
power supply indicated on adapter corresponds with
outlet voltage. The battery indicator light will turn blue
to indicate the unit is charging. All four LED lights
will turn on when battery is fully charged. It takes
approximately 2 hours to fully charge the battery. It is
suggested to fully charge battery before using unit.
Unplug adapter when charge is complete.
FILLING WATER TANK
1. Ensure unit is turned off and unplugged.
2. Remove water tank from unit by pulling on tabs at
the top of water tank (fig. 3).
3. Remove cap on clean water tank (fig. 4).
4. Fill with clean water, tilting unit slightly forward to
prevent spilling. Once water tank is filled to top of
reservoir* (fig. 4), replace cap. Do not overfill water
tank.
5. Reattach water tank to unit by placing base of
water tank in unit first and then pushing top until it
clicks into place (fig. 5).
NOTE: Unit must be unplugged while filling tank.
NOTE: Do not add harsh cleaning materials, caustics,
acids, scented perfumes, oils or cleaning products to
the water or the water tank as this may damage the item
or make it unsafe to use. Only use clear and pure water.
The use of distilled water is recommended in areas with
hard water to avoid lime scale deposits.
FIG.1
FIG.2
FIG.3
J
FIG.4
FIG.5