ViaSat SurfBeam, Руководство по установке и настройке

Страница: 13 / 30

SurfBeam Satellite Modem Installation and Configuration Guide
Rev. B VSD-200292-02-085
2-1
2. Connecting and Configuring the Equipment
Figure 2-1 shows the connectors on the SM rear panel. The TEL , LINE ,
and
USB
connectors are NOT currently used.
Connect the SM as follows:
1. Make sure the Support PC has been shut down normally, and is off.
2. Make sure the Satellite Modem is NOT connected to the in-line
power supply.
Figure 2-1 SurfBeam Satellite Modem Connectors
3. Connect an Ethernet cable as shown in Figure 2-2. Do not plug the
power cord on the in-line power supply to the power source. Do not
use the USB port to connect the Support PC or the user’s CPE.
Figure 2-2 SurfBeam Satellite Modem Connections
POWER
USB
ETHERNET LAN
RX IN
TX OUT
TEL
LINE
MODEM
Note The Satellite Modem
has no power on/off switch.
To apply or remove power
from the SM, connect or
disconnect the in-line power
supply from the power
source. The SM will start-up
every time power is applied.
SurfBeam
SM
Ethernet
Cable
TX to ODU
RX from ODU
In-Line PS
Support PC
Note Unless otherwise
instructed, the modem comes
preconfigured for the proper
operating frequencies, and
steps 3 through 13 should NOT
be perfomed!