TLC BOOST/BOOST XL AIR SOURCE KIT
USER MANUAL
INSTALLATION INSTRUCTIONS
CONNECTING TO THE BATTERY USING THE 2-PIN SAE TERMINAL RINGS
The Terminal Rings allow you to mount the compressor permanently to a vehicle and also provide a more
practical way of using it as a portable. Do not connect the Red Terminal Ring to any power source other
than the Positive (+) Terminal of your vehicle’s battery
.
a. Make sure the vehicle’s engine and ignition are off.
b. Install the Red Terminal Ring on the Positive (+) terminal post of your battery, this can be done by
removing the nut that holds the clamp in place, installing the terminal ring, and re-tightening the
nut. Refer to your vehicle’s owner’s manual for help if needed.
c. Install the Black Terminal Ring on the Negative (-) terminal post of your battery or other
ground source.
d. Connect compressor power cord to the 2-Pin SAE terminal.
MOUNTING THE COMPRESSOR
a. Using the hardware provided, mount the tank on a FLAT, UPRIGHT, AND SECURE location.
b. Route the compressor’s power cord to the terminal rings and connect using the 2-Pin SAE plug.
c. If it’s necessary to mount the compressor in a place beyond the power cord’s reach to the
Terminal Ring attachment, refer to the amp draw chart on the last page of this manual and use
appropriate gauge wire to extend your battery Terminal Ring attachments. When in doubt, always
use the next larger wire size.
IMPORTANT NOTES:
a. If mounting in the engine compartment, open your hood to allow maximum cooling of the
compressor unit during prolonged use. The cooler the ambient temperature, the less chance the
compressor will overheat.
b. This compressor is moisture & dust resistant, but NOT DIRT OR WATERPROOF. Do not mount
compressor in locations where the unit is likely to come in contact with the elements.
OPERATING THE COMPRESSOR
To avoid draining your battery and assure the compressor is getting the proper amperage, make sure
your vehicle’s engine is running during operation, especially if using for a prolonged period of time.
Make sure the air filter is installed, as this is a vital component to the longevity of your compressor.
a. Connect the Coil Hose Stud to the Quick Connect Coupler on your TLC BOOST/BOOST XL tank.
This can be done by simply pushing the Stud into the Quick Connect Coupler.
b. Connect the TLC Inflator or Blow Gun to the other end of the Coil Hose.
c. Turn on your TLC BOOST/BOOST XL by flipping the switch to the ON (I) position.
d. The compressor will start running and automatically shut off when the reservoir has been filled to
max pressure, this can take up to 3 minutes depending on what model you have.
e. You’re now ready to perform your pneumatic tasks!
f. When done using, disconnect the Coil Hose by pulling back on the Quick-Connect Coupler collar.
Be sure to hold the hose as built-up pressure can cause a slight burst during removal.
