ViaAqua Cube Star CC-15S-UV, Буклет

Страница: 6 / 10

4.
8 i
n (
12
cm
)
fro
m t
he w
al
l
6 7
IV - FILTRATION SET UP
Open canopy and light fixture (Fig. 2).
A. Intallation of micro filter bag, collection cup & Protein skimmer
1. Install micron filter bag. The clasp will attach to the left side
of the filter chamber (Fig. 3).
2. Rinse the protein skimmer with hot water and install
suction cup bracket (Fig. 4).
3. Position the skimmer in the first chamber so the suction cups face the
left side of the filter. Verify the airline tubing is accessible (Fig. 5).
4. Verify the salinity is 10.021-10.025.
5. Connect a small piece of tubing to the air pump (Fig. 6).
6. Connect the inline air control valve (Fig. 7).
7. Collection tray goes directly over the micron filter (Fig. 8).
8.
Reinstall skimmer so that the skimmer discharge is touching the
collection tray (Fig. 9).
9.
Using the air control valve adjust bubbles are about ¾”-1 ¼” below
discharge elbow.
Helpful hints for protein skimmer (see Troubleshooting in page 12)
DIRECTION FOR INSTALLAION
Required tools: Flat head screw driver.
NOTE: When adding water to the aquariums don’t use any water conditioners that
contain polymers. It is recommended to use RO water with synthetic sea salt or buy
salt pre-made from you local fish store. If water conditioners with polymers are used
the skimmer will not work properly until it is removed from the water.
I - CHECK FOR LEAKS
On a perfectly flat level surface fill the aquarium with water to verify that there
are not any leaks. Now that there are not any leaks remove the water from the
aquarium. Never lift the aquarium with water either scoop or siphon water from
the aquarium.
II - AQUARIUM LOCATION
1. Do not put the aquarium directly in the front
of a window.
2. Do not put the aquarium next to a door
that leads to the outside. Any consistent
draft will make it very difficult to maintain a
stable temperature.
3. Find a leveled surface to place the stand
and aquarium. If you are not placing the
aquarium on an aquarium stand verify that
the surface is flat, level and strong.
NOTE: Water weights approximately
8 pounds per gallon.
4. Make sure no part of the aquarium
hangingoff the stand
5. Position the aquarium a minimum of
4.8” (12cm)from the wall.
6. Keep out of reach of children.
III - ELECTRICAL SUPPLY
1. Plug in all electrical aquarium appliances directly into
a GFCI electrical outlet only!
2. Do not plug into a extension cord.
3. Do not plug in the pump until the aquarium is full of water.
4. Always disconnect the power to all aquarium devices prior
to maintenance.