VIPRO VP7710 User’s Manual
55
55
55
55
DRAM Clock/Drive Control
DRAM Clock/Drive Control
DRAM Clock/Drive Control
DRAM Clock/Drive Control
DRAM Clock
DRAM Clock
DRAM Clock
DRAM Clock
The chipset supports synchronous and asynchronous mode between
host clock and DRAM clock frequency.
Settings: [200MHz, 266MHz, 333MHz, By SPD]
DRAM Timing
DRAM Timing
DRAM Timing
DRAM Timing
The value in this field depends on the memory modules installed in your
system. Changing the value from the factory setting is not
recommended unless you install new memory that has a different
performance rating than the original modules.
Settings: [Manual, Auto By SPD]
SDRAM C
SDRAM C
SDRAM C
SDRAM CAS Latency [DDR/DDR2]
AS Latency [DDR/DDR2]
AS Latency [DDR/DDR2]
AS Latency [DDR/DDR2]
This item is for setting the speed it takes for the memory module to
complete a command. Generally, a lower setting will improve the
performance of your system. However, if your system becomes less
stable, you should change it to a higher setting. This field is only
available when “DRAM Timing” is set to “Manual”.
Settings: [1.5/2, 2/3, 2.5/4, 3/5]
