Getting started
Start by carefully removing any add on boards or MiSTer components from your DE10 Nano board,
if applicable. A USB hub expansion such as the BlisSTer can be left in place but please disconnect
all cables. Disconnect any Ethernet or USB cables and, if MiSTer software is installed, remove your
MiSTer system SD card and store it away safely.
Insert the female end of the supplied jumper cable onto the connector labelled J2, as shown in the
picture below.
Note the orientation of the jumper cable. J2 has two rows of 4 pins, the jumper cable should be
placed at the back, that is, on the row of pins that is closest to the SCART connector. This row of
pins is highlighted in yellow on the overview picture. The red cable should be on the right (with the
SCART connector at the back of the board).
